Teebaud Non-skid Rug Underlay

Installation Instructions

Teebaud® is a multi-purpose non-skid underlay pad. It can be used on wall-to-wall carpeting or on smooth flooring surfaces. In order to obtain maximum satisfaction and the best results with Teebaud, here are the installation procedures to be followed:

RUG on wall-to-wall carpeting:

Cut Teebaud about 1"-3" smaller than the rug to be installed
Remove the plastic release liner
Place Teebaud's white side down, facing the wall-to-wall carpeting
Then place the rug on top of Teebaud's gray side

RUG on smooth flooring surface:

Cut Teebaud about 1"-3" smaller than the rug to be installed
Remove the plaster release liner
Place Teebaud's gray side down, facing the smooth surface
Then place the rug on top of Teebaud's white side

CUTTING
Teebaud can be easily cut with scissors or a utility knife.

FLOOR PREPARATION
Prior to installing Teebaud, the floor should be vacuumed, clean and dry. Do not install Teebaud on a wet floor. In order to obtain a long-lasting non-skid performance, avoid frequent removal and re-installation of Teebaud from its designated installation area.

OVERSIZED RUGS
If several pieces of Teebaud are necessary for one rug, simply apply as many pieces as needed, side-by-side. Taping or splicing is NOT necessary.

CLEANING
Teebaud can be hand rinsed and air-dried.
Teebaud, when installed on a smooth surface, may leave an inoffensive light residue which is water soluble. The residue can be cleaned with water or common household cleaners, such as 409 or Windex, subject to specific floor finish/surface manufacturing guidelines.